Jump to content



Recommended Posts

I just finished setting up a re-creation of "demonharold" pose of Nino. I set up the mini, cleaned the flash lines, preped the fenced grave base... then got scared of trying to drill the pin hole in the fence post. I then had the bright idea of putting my tiny bit in my dremel and setting it on its slow rpm. I did a test drill on a tab and, huzah! It worked beautifuly! I set to work placing the bit in the fence post and trying to get it so it wouldnt drill out the side....Everything went perfect, untill I tried to place the fence on the base...I had drilled the hole on the WRONG side...:banghead:

Aaarghh!!! Now I have to start all over....lesson for the day,

Fit twice ...then check again...THEN drill.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...

Important Information